counters

Mutiny Hall

Posted by Lavrans Mathiesen

Mutiny hall was a short lived pub.

Another tap tower view
Another tap tower view

This was a classic job where at first I was just going to build the bar top and a few small boxes for the back. The job morphed into much more than that, with additional work including:

  1. Several days of demo.
  2. Framing new walls and re-framing old ones.
  3. Building up the pony wall under the bar top (which was later drilled to a shocking extent by the superintendent- an electrician who also did a lot of the plumbing on this project).

    Tap tower detail- Pomelle Bubinga surrounded by Sapele
    Tap tower detail- Pomelle Bubinga surrounded by Sapele
  4. Consulting on plumbing, etc.
  5. Building up partition walls.
  6. Platforms for raised booth areas.
  7. Wainscotting.
  8. Trim around windows.
Tap tower showing curve
Tap tower showing curve
Tap tower, installed with tpas
Tap tower, installed with tpas
Tap tower with taps
Tap tower with taps
Tap tower, ready for install
Tap tower, ready for install

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

I can’t find the pictures for the paneled wall under the bar, but I still have a few of the bar top.

Bar top, outside corner
Bar top, outside corner
Bar top outside corner
Bar top outside corner
Bar top, inside corner before drink ledge added.
Bar top, inside corner before drink ledge added.
Bar top, from service edge
Bar top, from service edge

Boffice

Posted by Lavrans Mathiesen

A recent project to take advantage of a house with a boat slip in the basement. A bare aluminum shell was supplied with a bare sketch of a cabinet layout, but the rest of the design and materials was left to Molior to design and install.

image

We ordered cabinets from Abodian to match the cabinets in the house, and then proceeded to fill in the details.

image

First step was to define the ceiling. We were aiming for “fishing boat chic”.

image

This is after the cabinets and counters were installed. The ceiling is Okubo panels with Sapele battens. The walls are upholstered panels.

image

The finished look from the windows at the bow.

image

May the bow Windows Molior created a sill with a chart of Bristol Bay made with Maple stringing, Pomelle Bubinga veneer, and a carved salmon of Walnut.

image

To create a standing desk Molior built a writing table box. Sapele with Pomelle Bubinga panels and drawer front and a leather top.